Nitrile rubber is a mixture of acrylonitrile and butadiene. It has excellent resistance to petroleum and non-polar solvents, and it also has good mechanical properties. These properties mainly depend on the content of acrylonitrile in the modified rubber. When the acrylonitrile content is higher than 50%, it has a strong resistance to mineral oil and fuel, but its elasticity and permanent compress...
The main characteristics of fluororubber are high temperature and chemical resistance, good resistance to aging and ozone, and very low air permeability. Even under very severe working conditions, it still has very good wear resistance. Fluorine rubber can withstand an operating temperature of +200 degrees or below, and it can also be operated without oil for a short time. Fluororubber can resist ...
Rubber intake hose is widely used in automobile engines, and other mechanical equipment. It has good sealing performance, high and low temperature resistance, and long life span. It is also known as the "respiratory tract of a car engine". The intake hose is composed of an intake manifold and an intake manifold. The air enters from the air inlet and passes through the air filter. This section of h...
Silicone tube: also known as silicone tube. It is used as carrier for liquid, gas and other materials circulating and coating. High Pressure Silicone hose is a kind of rubber tube, oil-resistant and heat-resistant. Silicone tube is made by adding raw material of silicone rubber to a double-roller mixer or a closed kneader, and gradually adding white carbon and other additives to repeatedly refinin...
Rubber tube is a type of tubular rubber products used to transport gas, liquid, slurry or granular materials. It is composed of inner and outer rubber layer and skeleton layer. The material of skeleton layer can be cotton fiber, various synthetic fibers, carbon fiber or asbestos, steel wire, etc. The rubber tube structure is usually divided into: inner rubber layer, outer rubber layer and skeleton...
EPDM rubber hose is made of EPDM material after thermal vulcanization processing, generally extruded by an extruder (in a few cases it can also be formed by compression molding). EPDM rubber hoses are mainly used in engines, water tanks, radiators of automobiles and construction machinery. The technology of rubber hoses is generally distinguished according to the types of rubber hoses. In general,...
online service
