A rubber bushing is a highly elastomer component that can be made from ordinary rubber. The elastic modulus of rubber bushing is small, and the elastic deformation is large after being loaded, so as to absorb impact and vibration. It can be subjected to multiple loads at the same time, but its high temperature and oil resistance is worse than that of steel bushings. The shape of rubber bushi...
Rubber is widely used in daily life, but some of its elements are prone to external interference and instability, which brings us serious problems in daily use and factory processing. The most obvious problem is the yellowing of rubber. The essence of rubber yellowing is the deterioration of the physical and chemical properties and mechanical properties of rubber in the process of processing, stor...
Raw rubber is elastic and lacks the plasticity necessary for processing, so it is not easy to process. In order to improve its plasticity, it is necessary to plasticize the raw rubber, so that the coordination agent can be easily dispersed in the raw rubber in mixing process. Meanwhile, in the rolling and forming process, it is also helpful to improve the permeability of the rubber into the fabric...
The process of converting plastic rubber to elastic rubber is called vulcanization. It is to add a certain curing agent such as sulfur, curing accelerator and so on into the semi-finished products made of raw rubber. In the vulcanization tank in the specified temperature heating, heat preservation of the raw glue between the linear molecules linked to each other into a three-dimensional network st...
Vulcanized elastic rubber is called vulcanized rubber, also known as soft rubber, commonly known as "rubber". Vulcanization is one of the most important technological processes for rubber processing. All kinds of rubber products must be vulcanized to obtain the ideal performance. Unvulcanized rubber in use is not of use value. But insufficient sulfur or curing time is not enough to make...
With the increase of room temperature vulcanization materials and the appearance of high temperature vulcanization, the vulcanization temperature tends to two extremes. From the improvement of curing efficiency, it should be considered that the higher the curing temperature, the better. But in fact we can not infinitely increase the curing temperature. Rubber is a high polymer, high temperature wi...
online service
