-
1.Plate rubber bearing: except under special conditions (cold areas), it has basically replaced the commonly used bearings like linoleum cushion, curved steel plate, reinforced concrete pendulum and other forms. The allowable compressive stress of rectangular and circular bearings is 10MPa, which is suitable for Bridges with small spans. It is not suitable to use spherical crown rubber bearings or...
-
Rubber crash pads are widely equipped in the chairs of automobiles, ships, air crafts and other vehicles, furniture so on, which serves as support of passengers’ thigh and butt. If the stiffness of the lower buttock of the cushion is matched with the stiffness of the leg support, the leg will feel numbness or pressure, foreign body sensation, resistance sensation (hereinafter uniformly referred to...
-
Rubber sound insulation cushion is a kind of building vibration insulation products made of pure rubber foam, with good sound insulation, waterproof and moisture-proof, non-toxic environmental protection, heat insulation, good resilience, light weight, long service life and other characteristics. It is professional sound insulation supplies used to solve the problem of building noise. This kind of...
-
Rubber gasket is now the most basic and widely used gasket. It is made of synthetic rubber that vulcanized with polymers, added fillers, pigments and various additives. Synthetic rubber has very excellent compressibility and resilience. Only need very little pre tightening force, this rubber can play a role of effective sealing under low temperature low pressure conditions. Rubber gasket is ...
-
EPDM hoses are generally used as delivery pipes, which is divided into conveying hose and suction hose. Various types of cloth inserted hose are made of different materials according to different transmission medium, with reasonable structural design, good quality and durability. EPDM hose is a flexible hose used for conveying or absorbing (negative pressure condition) various liquids fluids...
-
Rubber molded products refer to the products made by placing the mixed rubber blank in a model and pressing them with a vulcanizer under the specified time, pressure and temperature conditions, which are called rubber molded products. Rubber molded products are the most diverse and widely used special products in rubber products. Its characteristics are: easy manufacturing, accurate appearance, sm...
-
Generally, the oil pipes of motorcycles are made of oil-resistant rubber. Rubber is a thermoplastic elastomer and has elastic. Therefore, the fuel pipes of motorcycles are basically universal. Nitrile rubber is the most common oil-resistant rubber. Nitrile rubber is a mixture of acrylonitrile and butadiene. It has excellent resistance to petroleum and non-polar solvents, and it also has good mecha...
-
Rubber cushions are generally made of rubber, and are a kind of rubber products used to control the impact and shock from the outside when the rubber rebounds after absorbing vibration. Rubber cushions have different shapes according to different use environments, but it has a feature that is long life when in use, can be used in any environment, corrosion resistance, high and low temperature resi...
-
The through-hole rubber sheath is mainly distributed at the interface between the engine and the cab, the interface between the front cabin and the cab (2 places on the left and right), the interface between the four doors (or a rear door) and the compartment, and the inlet of the fuel tank,which have the functions of grinding, waterproofing and sealing. The through-hole rubber sheath is a kind of...
-
Air filter hose refers to the section of rubber hose that air enters from the air inlet and passes through the air filter until it is to enter each cylinder. Since the rubber hose is located near the engine, it needs to have the following conditions: 1.High temperature resistance: The rubber hose is directly connected to the engine cylinder head, and the temperature of the engine cylinder head can...
online service
